VariFlame Conversion Kit

The VariFlame Kit should only be used on the following CVA Muzzleloaders; ACCURA MR / MRX, ACCURA LRX, ACCURA PR, WOLF, AND OPTIMA. NOT RECOMMENDED TO BE USED WITH ACCURA, ACCURA V2, AND ACCURA LR MODELS. 

CVA only recommends the VariFlame Conversion Kit to be used with standard blackpowder charges, up to 150 grains by volume of pelletized, Pyrodex or Triple 7 loose powder, or, up to 120 grains by volume of Blackhorn 209.

INSTRUCTIONS FOR INSTALLING VF QRBP:

1. Remove the forend and ramrod from the bottom of the barrel, and the barrel from the frame.

2. Using the firing pin removal tool that was supplied with your CVA, or a slotted flat head screw driver, remove the firing pin bushing. Replace your current firing pin and firing pin bushing with the supplied firing pin and bushing from the conversion kit. 

3. While barrel is off of the frame, remove current 209 QRBP from muzzleloader, and install the new VF QRBP into the back of the barrel finger tight. Using the supplied wrench, tighten the breech plug into the barrel. Loosen the breech plug, and retighten for a second time. The new QRBP will now be fitted to your barrel, and you no longer need the QRBP tool once this step has been completed.

4. Reinstall the barrel onto the frame, and forend under the barrel with ramrod.